Sensorsoft ST6105J Manuel d'utilisateur télécharger pdf (Page 14)

Sensorsoft Remote Watchman Express/Client User Manual

Modem Type: Select the type of modem attached or installed on your computer.

Modem Port: Select the COM port where your modem is attached or installed.

Lock modem port: Select this checkbox if this is the only SSD you are monitoring. This will

improve reliability and prevent other applications on your computer from using the modem. By

deselect this option other instances of this software will be able to use pager alerts too.

Advanced SMS-TAP Settings: This frame is not enabled for DTMF paging type.

 Connect Time-out: We do not recommend that you make changes to this setting unless

you are getting connect time-out messages, because the remote modem is taking a long

period of time to answer the line. If you increase this setting, you will also need to make

changes to the S7 setting of the applicable modem setup file. The S7 setting should be 2

seconds less than this connect time-out setting. Use the up and down buttons to make

changes to the setting.

 Response Time-out: We do not recommend changes to this setting unless you are

getting no-response errors during pages. In the case of slower paging providers, you

might be required to set the value of the Response Time-out to a longer period (in

seconds) for successful message delivery.

 Retries on failure: If this software detects that a page message was not delivered due to

an error, it will attempt to re-send the message the number of times you indicate here. If

the message is not delivered successfully during the set number of retries, then the

software will stop trying to send the message.

 Delay before fail retry: This setting controls the length of time in seconds that the

software will wait after a paging message fails before attempting to send the message

again.

Events: Each event type required must be specified individually. A check mark in the Enable box

beside the Event indicates that a message will be sent for that event. Ensure that you have

selected the correct event type before completing the following details. Please note that you must

click the Apply button before highlighting a new event type, in order for your changes to be

saved. Events are arranged in order of numerical priority from lowest (top) to greatest (bottom).

The Retry state is considered the highest priority.

Send message at a scheduled time: By selecting this event you can set up the day of the week

and time you would like a scheduled pager message to be sent. If a scheduled message has been

sent, its time specification must not be reprogrammed until 10 minutes after the event occurred.

Figure 4b

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Pas de commentaire

Sensorsoft ST6105J Manuel d'utilisateur Page 14